Server connection details
| Server Address | |
| Server IP Address | 52.57.1.136 |
| Server port | 47699 |
| Purpose | Vehicle | |
| Installation | Professional |
| Weight | 110 g (3.88 oz.) | |
| Size | 89x55x25 mm (3.5×2.17×0.98 in) |
| Internal antenna (GNSS) | ||
| External antenna (GNSS) | ||
| GPS |
| Cellular network type | GSM Quad Band | |
| Internal antenna (Connection) | ||
| External antenna (Connection) | ||
| Cellular network generation | 2G |
| 1-Wire interface | ||
| RS232 interface | ||
| RS485 interface | ||
| Number of outputs | 2 | |
| Number of inputs (all types) | 5 | |
| ACC/Ignition input | ||
| Discrete inputs | ||
| Analog inputs | ||
| Impulse inputs | ||
| Outputs |
| Battery capacity | 550 mAh | |
| Built-in battery | Optional |
| Emergency button | ||
| Driver ID reading | ||
| External temperature sensor reading |
| Tracking modes | Continuous, Interval | |
| Odometer | ||
| ECO driving |
| External power cut off | ||
| Car crash |
| Network signal level | ||
| Network operator ID | ||
| GNSS signal level | ||
| External power source voltage | ||
| Internal battery level |
| CAN/OBDII reader type | External | |
| CAN/OBDII parameters | Speed, fuel level, fuel consumption, engine RPM, throttle position, mileage, inst. fuel consumption, engine hours |
| Server connection setup over SMS | ||
| Remote device configuration | Yes (over GPRS) | |
| Remote outputs control | Yes (over GPRS) | |
| Firmware update OTA |
| CE | ||
| FCC |
How to connect to TrackSystem server
Automatic activation (recommended)
The software platform supports automatic device activation by applying APN settings, server address and port, as well as recommended tracking mode though the SMS channel. Normally you don’t need to configure anything manually. Just install the SIM card, switch the device ON and make sure it is located in the place with good GPS signal reception.
You also need to keep the device with initial factory settings, in particular:
- Do not set any password, keep it clear (as by default)
- Do not set any master number prior to the device activation
- Do not set local Time zone, it must be UTC+0h (as by default)
Manual activation
In case automatic activation failed, you can try to register the device manually by sending following command to the device:
$AL+COMM=0000,3,{sms_gateway},,{apn},{apn_user},{apn_pass},1,52.57.1.136,47699,300,rn
$AL+UNPM=0000,{device_id_generated_by_api_server},0000,9998,7,7,7,7,4,10rn
The <APN> parameters depend on your GSM carrier.